EVE with some clothes on :) miniature marvel (WiFi is Edimax)
Getting ever closer to next weeks Kickstarter launch
Comments
-
Please login first in order for you to submit comments
Banners
Forum Login
Latest posts!
Srf comms with xcm Using windows 7
Short story-
Connected with ftdi cable
I am able to download config, and enter command mode with triple guard and recieve 'OK' response
After I enter command mode, a command...
Re: Arduino High Power Mo Hi Miles,
thanks for the answer. The FET is good but still not working. I also checked the PWM in and out of the IC and it is there.
I will try to remove the IC and user jumpers instead. Just to...
Re: URF + XRF = OTAMP ? Hello.
This is the message i get in verbose mode:
Code Removed
i guess "avrdude: Send: 0 " is the reset command being sent ?
anyway, I've tryed to add a LED to the...
Re: OTAMP using SPI I'm sure it's something we can work on between us, I know Andrew has done bootloader hacking in the past.
Agree about on time v reliability, of course you could say firmware updates are a special...
Re: Unable to run the bis Hi,
It does work at 3v, I'll check using 2 x AA's and report back what I see. What batteries are you using (brand and condition?)
If you can measure the drop (assume multimeter) you are...
Re: OTAMP using SPI If you can find a well documented SPI loader, we could "look at it". If you can find something that supports a tiny too, then even better.
Slow xtal means slow upload, it being awake for longer,...
Re: Arduino High Power Mo Hi,
Both LED's light?
Do both channels of the driver chip follow in tandom with the LEDs? (cannot recollect the microchip TCxxxx part number but it's written on top if you need a datasheet) you...
Re: URF + XRF = OTAMP ? Hi,
Try putting an LED (or even better a scope) on the reset line to see if there's a blip (going low). 99% of everything we've seen comes down to resets. The only other thing is mixing up RX&TX....
Re: Eve for monitoring sm Hi,
EVE as hardware could provide a lot of what you are in need of, the software to run it however is down to you. So far the best supported radio is ours as you'd expect. The RFM12B the next (but...
Re: Problem on XBBO inter Hi,
I suspect the XBBO regulator cannot provide the 330ma the ARF requires. Perhaps try powering directly with 2 x AA cells for a quick test. The XBBO was released for the XRF and before the ARF...
Problem on XBBO interfaci We are currently using ARF on Arduino through XBBO break out board. So that the Arduino is able to communicate with PC. On the PC side, we use Explorer Plus - 5 in 1 usb interface to connect with...
Eve for monitoring smart G'day,
I'm looking to use my Raspberry Pi to monitor a Power-One Aurora PVI-6000 solar inverter (via an RS-485 to USB adapter), an iCredit 500 smart meter (equipped with ZigBee Smart Energy...
Will you be making right handed versions?